FixVault
Home › Chrysler › 2005 › Pacifica Base, 3.8 L › Repair and Diagnosis › Body & Frame › Door Locks › Power Liftgate System › Pinch Sensor › Removal

Pinch Sensor: Removal

  1. Open the liftgate.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the trim panel from liftgate. Refer to INTERIOR/EXTERIOR for the procedure.
  4. Disconnect the pinch sensor wire harness connector.
  5. Remove the screws holding the pinch sensor to liftgate.
  6. Feed the pinch sensor wire harness out of the liftgate and remove the sensor from the vehicle.
About FixVault