Charging System Test Procedure

Press ENTER to begin charging system test.

Fig 1: Micro 570 Analyzer Screen Display - Press Enter For Charging Test
Courtesy of HYUNDAI MOTOR CO.
ENTER button is pressed, the tester displays the actual voltage of alternator.
Press ENTER to test the charging system.

Fig 2: Micro 570 Analyzer Screen Display - Enter To Test Charging System
Courtesy of HYUNDAI MOTOR CO.
Turn off all electrical load and rev engine for 5 seconds by pressing the accelerator pedal.

Fig 3: Micro 570 Analyzer Screen Display - rev engine for 5 seconds (1 Of 2)
Courtesy of HYUNDAI MOTOR CO.
Press ENTER.

Fig 4: Micro 570 Analyzer Screen Display - rev engine for 5 seconds (2 Of 2)
Courtesy of HYUNDAI MOTOR CO.
The MICRO 570 analyzer charging system output at idle for comparison to other readings.

Fig 5: Micro 570 Analyzer Screen Display - Engine At Idle
Courtesy of HYUNDAI MOTOR CO.
Take a relevant action according to the test results by referring to the table below after shutting off the engine and disconnect the tester clamps from the battery.

Fig 6: Micro 570 Analyzer Screen Display - Diode Ripple Normal
Courtesy of HYUNDAI MOTOR CO.