Diagnostic Procedure

STEP	INSPECTION		ACTION
1	PERFORM PCM DTC INSPECTION Perform the PCM DTC inspection using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [MZR 2.5] .) (See ON-BOARD DIAGNOSTIC TEST [MZI 3.7 V6] .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR 2.5] .) (See DTC TABLE [MZI 3.7 V6] .)
1		No	Go to the next step.
2	INSPECT BATTERY Inspect the battery. (See BATTERY INSPECTION [MZR 2.5] .) (See BATTERY INSPECTION [MZI 3.7 V6] .) Is there any malfunction?	Yes	Recharge or replace the battery, then go to Step 4. (See BATTERY RECHARGING [MZR 2.5] .) (See BATTERY RECHARGING [MZI 3.7 V6] .) (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .) (See BATTERY REMOVAL/INSTALLATION [MZI 3.7 V6] .)
2		No	Go to the next step.
3	INSPECT GENERATOR Inspect the generator. (See GENERATOR INSPECTION [MZR 2.5] .) (See GENERATOR INSPECTION [MZI 3.7 V6] .) Is there any malfunction?	Yes	Replace the generator, then go to the next step. (See GENERATOR REMOVAL/INSTALLATION [MZR 2.5] .) (See GENERATOR REMOVAL/INSTALLATION [MZI 3.7 V6] .)
3		No	Go to the next step.
4	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from the auto light/wiper control module memory using the M-MDS. (See CLEARING DTC [AUTO LIGHT/WIPER CONTROL MODULE] .) Perform the auto light/wiper control module DTC inspection using the M-MDS. (See DTC INSPECTION [AUTO LIGHT/WIPER CONTROL MODULE] .) Is the same DTC present?	Yes	Replace the auto light/wiper control module, then go to the next step. (See AUTO LIGHT/WIPER CONTROL MODULE REMOVAL/INSTALLATION .)
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCs ARE RECORDED Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [AUTO LIGHT/WIPER CONTROL MODULE] .)
5		No	DTC troubleshooting completed.