Rear Combination Light Assembly: Inspection

Apply battery voltage between the connector terminals to check the lighting condition of the light.

CAUTION:

When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
Incorrect polarity connection may cause internal LED damage.

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Specification
3 (+) - 2 (-)	Apply battery voltage.	Stop light on
4 (+) - 2 (-)		Tail/side marker light on
1 (+) - 2 (-)		Turn signal light on

Replace the harness and bulb if it is found defective.

NOTE: Since LED (Light Emitting Diode) is used for the tail light and stop light, replace the combination light assembly if the light does not illuminate.