Washer Level Warning System

1. Turn the ignition switch on. If the washer level warning light comes on, check the washer fluid level, and add washer fluid if necessary.
2. Remove the front bumper, then disconnect the 2-P connector from the washer fluid level switch. Connect the "A" (GRN/BLK) terminal to the "B" (BLK) terminal with a jumper wire. The warning light should come on as the ignition switch is turned on. See Fig 1.
   • If the light comes on, the problem is the washer fluid level switch.
   • If the light does not come on, check for poor ground (G5 or 15), no power to the warning circuit, an open in the GRN/BLK wire to the gauge assembly, bad bulb, faulty warning circuit.

Fig 1: Identifying Washer Fluid Level Switch Terminals

Courtesy of AMERICAN HONDA MOTOR CO., INC.