Transaxle Housing: Reassembly
- Expand snap ring and install ball bearing part way into transaxle housing. Release snap ring. Press ball bearing into transaxle housing until snap ring engages with groove in ball bearing.
- Using hammer, Driver (07749-0010000) and Adapter (07LAD-SM40100), install secondary gear oil seal in transaxle housing.
CAUTION:
Ensure ball bearing is installed with groove of ball bearing facing inside of transaxle housing so snap ring engages in ball bearing when ball bearing is fully installed. Ensure snap ring fully engages in ball bearing.
NOTE:
If secondary gear, roller bearings, bearing races, thrust shim, washer, transaxle housing or torque converter housing are replaced, secondary gear bearing preload must be checked before installing secondary gear oil seal. Refer to SECONDARY GEAR BEARING PRELOAD
under TRANSAXLE REASSEMBLY.