Bleeding Procedures
CAUTION:
Use only clean brake fluid. Ensure no dirt or other foreign matter contaminates brake fluid. DO NOT mix different brands of brake fluid as they may not be compatible. Avoid spilling brake fluid on car, as it will damage paint. If brake fluid contacts paint, immediately flush with water.
- Reservoir on master cylinder must be full at start of bleeding procedure. Refill reservoir after bleeding each wheel. With aid of assistant, slowly pump brake pedal several times; then apply steady pressure. Loosen brake bleed screw to allow air to escape from system.
- Tighten bleed screw securely. Repeat procedure for each wheel in the following sequence:
- Right Rear
- Left Front
- Left Rear
- Right Front
- Road test vehicle and check brake performance.