Line Pressure Test
- With engine off, remove plug from line pressure tap on transaxle. See Figure . Attach Pressure Gauge Set (07406-0020400) to line pressure tap using NEW aluminum washer. Tighten hose fitting to 13 ft. lbs. (18 N.m).
- With shift lever in "P", start and operate engine at 2000 RPM. Note line pressure. Place shift lever in "N" and note line pressure.
- Line pressure should be within specification. See the HYDRAULIC PRESSURE TEST SPECIFICATIONS table. If line pressure is not within specification, see HYDRAULIC PRESSURE TEST TROUBLE SHOOTING table. Shut engine off. Remove pressure gauge set and install plug.
NOTE:
Clutch pressure should be checked at each clutch pressure tap on transaxle. See Figure
.