FixVault
Home › Acura › 1994 › Integra GS-R, 4D Sedan › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › Diagnosis & Testing › Set/Resume Switch

Set/Resume Switch

NOTE: This test procedure also tests cable reel in steering column.
  1. Disable air bag system. See AIR BAG RESTRAINT SYSTEM article in ACCESSORIES & EQUIPMENT. Connect SRS Test Harness "C" (07LAZ-SL40300) to cable reel 6-pin connector. Check for continuity between SRS Test Harness "C" connector terminal No. 2 (Light Green/Red wire on cable reel harness) and terminal No. 3 (Blue/Green wire on cable reel harness) with SET pressed. See Fig 1 . If continuity exists, go to next step. If continuity does not exist, go to step 3).
    Fig 1: SRS Test Harness "C" Terminal ID (Integra Test Harness Is Similar)
    G93D01464Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Check for continuity between SRS Test Harness "C" connector terminal No. 1 (Light Green/Black wire on cable reel harness) and terminal No. 3 (Blue/Green wire on cable reel harness) with RESUME pressed. If continuity exists, go to next step. If continuity does not exist, go to step 3).
  3. Remove SET/RESUME switch from steering wheel. See SET/RESUME SWITCH under REMOVAL & INSTALLATION  .
  4. Check for continuity between SRS Test Harness "C" connector terminals "A" or "A' " and "C" with SET pressed. If continuity exists, go to next step. If continuity does not exist, replace SET/RESUME switch.
  5. Check for continuity between SRS Test Harness "C" connector terminals "A" or "A' " and "C" with RESUME pressed. If continuity exists, go to next step. If continuity does not exist, replace SET/RESUME switch.
  6. If continuity exists in both steps 4) and 5), replace cable reel. See CABLE REEL under REMOVAL & INSTALLATION  . If continuity does not exist, replace SET/RESUME switch. See SET/RESUME SWITCH under REMOVAL & INSTALLATION  .
About FixVault