Fuel Gauge Sending Unit
WARNING: This page is about a different car, the 1995 Acura Integra. However, it is still accessible from the selected car via links, so may be relevant.
Remove rear seat and fuel pump access panel. Turn ignition off. Disconnect fuel gauge sending unit 3-pin connector. Using Fuel Sender Wrench (07GAC-SE0020A), remove sending unit. Measure resistance between sending unit terminal "B" and terminal "C" while moving float. See Fig 1 . Resistance must be as specified in FUEL GAUGE SENDING UNIT RESISTANCE table.
FUEL GAUGE SENDING UNIT RESISTANCE
| Float Position | Ohms |
|---|---|
| Full | 2-5 |
| 1/2 | 25-39 |
| Empty | 105-110 |