Fuel Pump: Testing

If you suspect a problem with the fuel pump, check that the fuel pump actually runs; when it is ON (II), you will hear some noise if you hold your ear to the fuel fill port with the fuel fill cap removed. The fuel pump should, run for two seconds when ignition switch is first turned ON (II). If the fuel pump does not make noise, check it as follows:

1. Remove the seat cushion (see REAR SEAT REMOVAL/INSTALLATION ).
2. Remove the access panel from the floor.
3. Disconnect the fuel pump 2P connector.
   CAUTION: Be sure to turn the ignition switch OFF before disconnecting the wires.
4. Connect the PGM-FI main relay 7P connector terminal No. 4 and No. 5 with a jumper wire.
   Fig 1: Connecting PGM-FI Main Relay 7P Connector Terminal No. 4 And No. 5 With Jumper Wire

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Check that battery voltage is available between the fuel pump 2P connector terminal No. 2 and body ground when the ignition switch is turned ON (II).
   Fig 2: Checking Battery Voltage Between Fuel Pump 2P Connector Terminal No. 2 And Body Ground

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
   • If battery voltage is available, check the fuel pump ground. If the ground is OK, replace the fuel pump.
   • If there is no voltage, check the wire harness (see TROUBLESHOOTING  ).