FixVault
Home › Acura › 1997 › Integra GS-R, 2D Coupe › Repair and Diagnosis › Accessories & Equipment › Cruise Control Systems › Component Tests › Set/Resume Switch

Set/Resume Switch

NOTE: This test procedure also tests clockspring in steering column.
  1. Disable air bag system. See AIR BAG RESTRAINT SYSTEM article. Remove instrument panel lower cover and knee bolster. Locate clockspring Gray 3-pin connector under steering column, next to SIR Yellow 6-pin connector. Depress SET button to ON position. Check for continuity between clockspring Gray 3-pin connector terminals No. 1 (Light Green/Red wire) and No. 2 (Blue/Green wire). If continuity exists, go to next step. If continuity does not exist, go to step 3).
  2. Depress RESUME button to ON position. Check for continuity between clockspring Gray 3-pin connector terminals No. 2 (Blue/Green wire) and No. 3 (Light Green/Black). If continuity exists, switch and clockspring are okay. If continuity does not exist, go to next step.
  3. Remove SET/RESUME switch from steering wheel. See SET/RESUME SWITCH under REMOVAL & INSTALLATION. With switch connector index on top, terminal No. 1 is on the left. Depress SET button to ON position. Check for continuity between switch terminals No. 1 and 3. Depress RESUME button to ON position. Check for continuity between switch terminals No. 1 and 2. If continuity exists at both switch positions, replace clockspring. See AIR BAG RESTRAINT SYSTEM article. If continuity does not exist, replace SET/RESUME switch.
About FixVault