FixVault
Home › Acura › 1998 › Integra GS-R, 4D Sedan › Repair and Diagnosis › External Pages › Different car › Section 1 (Heater System) › Testing › Heater Control Panel › Heater Fan Switch

Heater Fan Switch

WARNING: This page is about a different car, the 2001 Acura Integra, 2000 Acura Integra, and 1999 Acura Integra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove heater control panel. See HEATER CONTROL PANEL  under REMOVAL & INSTALLATION. With heater fan control lever (heater fan switch) in OFF position, no continuity should exist between terminals of 6-pin connector. See Figure .
  2. With fan control lever at 1, continuity should exist between terminals "A", "D" and "F". With fan control lever at 2, continuity should exist between terminals "A", "B" and "F".
  3. With fan control lever at 3, continuity should exist between terminals "A", "E" and "F". With fan control lever at 4, continuity should exist between terminals "A", "C" and "F". If continuity is not as specified, replace heater fan switch.
About FixVault