Cruise Control Main Switch: 3.5RL

1. Remove Traction Control System (TCS) and cruise control main switch from driver's switch panel. Disconnect main switch 5-pin connector. With switch in OFF position, continuity should exist between switch terminal No. 1 and terminal No. 2, and between terminal No. 4 and terminal No. 5. See Fig 1. Go to next step.
2. With main switch in ON position, continuity should exist between switch terminal No. 1 and terminal No. 2, and between terminal No. 3, terminal No. 4 and terminal No. 5. See WIRING DIAGRAMS . If continuity is not as specified, replace TCS/cruise control main switch.

Fig 1: Identifying Main Switch Connector Terminals (3.5RL)

Courtesy of AMERICAN HONDA MOTOR CO. INC.