Ignition Switch Test: 3.5RL

Disconnect negative battery cable. Remove lower instrument panel cover and driver-side knee bolster. Disconnect two 7-pin connectors from steering column harness. With ignition switch in appropriate position, check continuity between specified connector terminals. See Fig 1 and Fig 2 . If continuity is not as specified, replace ignition switch.

Fig 1: Ignition Switch Terminal Identification (3.5RL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Testing Ignition Switch Continuity (3.5RL)

Courtesy of AMERICAN HONDA MOTOR CO., INC.