Bleeding Cooling System
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Acura 3.5RL, 2003 Acura RSX, 2003 Acura MDX, 2003 Acura 3.5RL, and 2003 Acura 3.2TL. However, it is still accessible from the selected car via links, so may be relevant.
Always bleed air from cooling system after replacing coolant. Set heater for maximum heat. Remove radiator cap. Drain coolant reservoir. Fill coolant reservoir to MAX mark with 50/50 water-coolant mixture. Loosen bleed bolt and fill radiator to base of filler neck. Close bleed bolt when coolant flows out without bubbles. Tighten bleed bolt. With radiator cap removed, start and operate engine to normal operating temperature. Add coolant if necessary and check for leaks.