Remote Transmitters
NOTE:
Up to 3 transmitter codes can be stored in power door lock control unit memory. If a fourth code is entered, the first one stored will be erased. It is important to maintain time limits between steps, otherwise process will need to be repeated.
- Turn ignition switch to ON position. Within 1-4 seconds, aim transmitter at vehicle and push LOCK or UNLOCK button. Within 1-4 seconds, turn ignition switch to OFF position. Go to next step.
- Within 1-4 seconds, turn ignition switch to ON position. Within 1-4 seconds, aim transmitter at vehicle and push LOCK or UNLOCK button. Within 1-4 seconds, turn ignition switch to OFF position. Go to next step.
- Within 4 seconds, turn ignition switch to ON position. Within 1-4 seconds, aim transmitter at vehicle and push LOCK or UNLOCK button. Within 1-4 seconds, turn ignition switch to OFF position. Go to next step.
- Within 4 seconds, turn ignition switch to ON position. Within 1-4 seconds, aim transmitter at vehicle and push LOCK or UNLOCK button. Ensure that you can hear sound of door lock actuators. Within 1-4 seconds, push LOCK or UNLOCK button again. Go to next step.
- Within 10 seconds, aim transmitters to be programmed (up to 3) at vehicle and press LOCK or UNLOCK buttons. Ensure that you can hear the sound of door lock actuators after each transmitter code is stored. Turn ignition switch to OFF position. Remove key and confirm proper operation of transmitters after each transmitter code is stored. If vehicle is equipped with Driving Position Memory System (DPMS), DPMS can be turned ON or OFF by pressing and holding LOCK and UNLOCK buttons on transmitter simultaneously. Transmitter LED will blink once for remote DPMS ON, and twice for remote DPMS OFF.NOTE: For more diagnostic information on DPMS, see appropriate DRIVER'S POSITION MEMORY SYSTEMS article.