Rear Controller and Screen Removal/Installation

WARNING: This page is about a different car, the 2009 Acura MDX, 2008 Acura MDX, and 2007 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the headliner and display cover.

Remove the display cover.

Fig 1: Identifying Display Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the mounting bolts, disconnect the connectors (A) from the rear controller and screen.

Fig 2: Identifying Rear Controller And Screen Connectors
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the wireless remote control (A).

Fig 3: Identifying Wireless Remote Control, Cable And Rear Indicator
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws from the rear indicator (B).
Disconnect the cable (C) from the rear indicator.
Remove the screws, then remove the rear indicator sub printed circuit board (A).

Fig 4: Identifying Rear Indicator Sub Printed Circuit Board
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then remove the screen (A) and base (B). Disconnect the cable (C).

Fig 5: Identifying Screen, Base And Cable
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws and lock switches (A),

Fig 6: Identifying Lock Switches
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the cable (A), then remove the screws and the rear control main printed circuit board (B).

Fig 7: Identifying Rear Control Main Printed Circuit Board And Cable
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the parts in the reverse order of removal, and make sure the rear controller and screen connector are plugged in properly.