Transmission Range Switch Replacement

Raise the vehicle on a lift, and make sure it is securely supported.
Shift to N.
Remove the transmission range switch cover.

Fig 1: Identifying Transmission Range Switch Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the transmission range switch connector.

Fig 2: Identifying Transmission Range Switch Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the transmission range switch.
Make sure the selector control shaft is in the N position. If necessary, move the shift lever from P to N.
NOTE: Do not use the selector control shaft to adjust the shift position. If the selector control shaft tips are squeezed together it will cause a faulty signal or position due to play between the selector control shaft and the switch.

Fig 3: Moving Shift Lever From P To N Position
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Align the cutouts (A) on the rotary-frame with the neutral positioning cutouts (B) on the transmission range switch (C), then put a 2.0 mm (0.08 in.) feeler gauge blade (D) in the cutouts to hold the switch in the N position.
NOTE: Be sure to use a 2.0 mm (0.08 in.) blade or equivalent to hold the switch in the N position.

Fig 4: Aligning Rotary-Frame Cutouts With Neutral Positioning Cutouts On Transmission Range Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the transmission range switch (A) gently on the selector control shaft (B) while holding it in the N position with the 2.0 mm (0.08 in.) blade (C).

Fig 5: Identifying Transmission Range Switch And Selector Control Shaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Tighten the bolts on the transmission range switch while you continue to hold the N position. Do not move the transmission range switch when tightening the bolts. Remove the feeler gauge.

Fig 6: Transmission Range Switch Bolts W/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the connector securely, then install the transmission range switch cover (A).

Fig 7: Transmission Range Switch Cover W/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II). Move the shift lever through all positions, and check the transmission range switch synchronization with the A/T gear position indicator.
Check that the engine will starts in P and N, and does not start in any other shift lever position.
Check that the back-up lights come on when the shift lever is in R.
Allow the front wheels to rotate freely, then start the engine, and check the shift lever operation.