'04 model

SRS components are located in this area. Review the SRS component location index (see COMPONENT LOCATION INDEX ) and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS before testing the solenoid.

1. Remove the driver's airbag (see DRIVER'S AIRBAG REPLACEMENT ).
2. Remove the two screws, then disconnect the connector, and remove the switch.
   Fig 1: Identifying Switch Screws And Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Check for continuity between the terminals in each switch position according to Fig 2.
   • If there is continuity, and it matches Fig 2, but switch failure occurred on the cruise control input test, check and repair the wire harness on the switch circuit.
   • If there is no continuity in one or both positions, replace the switch.
     Fig 2: Checking Continuity Between Terminals In Switch Position

     Courtesy of AMERICAN HONDA MOTOR CO., INC.