Tire Pressure Sensor Replacement: Installation

WARNING: This page is about a different car, the 2008 Acura TSX and 2007 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use only wheels that have a "TPMS" stamp (A) on them.

Fig 1: Identifying TPMS Stamp

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
Install the tire pressure sensor (A) and the Washer (B) to the wheel (C), and tighten the valve stem nut (D) finger tight. Make sure the pressure sensor is resting on the wheel.

Fig 2: Tire Pressure Sensor And Washer W/Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Tighten the valve stem nut to the specified torque while holding the tire pressure sensor.
NOTE: Do not use air or electric impact tools to tighten a valve stem nut.
Lube the tire bead, and position the wheel so the tire machine (A) and tire iron (B) are next to the valve stem (C) and will move away from it when the machine starts. Then install the tire onto the wheel.

Fig 3: Identifying Tire Machine And Tire Iron
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Inflate the tire to 300 kPa (3.1 kgf/cm² , 44 psi) to seat the tire bead to the rim, then adjust the tire pressure (see WHEEL ALIGNMENT ).
NOTE: Make sure the tire bead is uniformly seated on both sides of the rim.
Check the valve stem nut tightening torque, then install the valve stem cap.
Check and adjust the wheel balance, then install the wheels on the vehicle. Torque the wheels to specifications.
Remove the jack stands, and lower the vehicle.
Connect the HDS and memorize the tire pressure sensor ID(s) (see MEMORIZING THE TIRE PRESSURE SENSOR ID ).