FixVault
Home › Acura › 2005 › TSX Standard › Repair and Diagnosis (Single Page) › Heating, Ventilation & A/C (HVAC) › HVAC Control Systems › Automatic HVAC System › Climate Control › Recirculation Control Motor Replacement

Recirculation Control Motor Replacement

  1. Open the glove box. Remove the damper from the glove box, then let the glove box hang down (see GLOVE BOX REMOVAL/INSTALLATION ).
  2. Remove the relays from the bracket.
    Fig 1: Recirculation Control Motor
    G05492682Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the 7P connector (A) from the recirculation control motor (B). Remove the self-tapping screws and the recirculation control motor from the blower unit.
    Fig 2: Identifying 7P Connector And Recirculation Control Motor
    G05492683Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
About FixVault