Forced Starting of Display

Special tools required 

SCS Service Connector 07PAZ-0010100

1. Remove the trunk trim (see TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
2. Turn the ignition switch OFF.
3. Connect the SCS service connector (A) to the navigation service connector (B) located behind the navigation unit.
   Fig 1: Identifying SCS Service Connector And Navigation Service Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Turn the ignition switch ON (II).
5. Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menu.
   NOTE: If the display fails to display the system link screen, refer to NO PICTURE IS DISPLAYED  .