Countershaft Bearing Replacement

Special Tools Required 

• Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A
• Driver 07749-0010000
• Attachment, 78 x 80 mm 07NAD-PX40100

1. Remove the countershaft bearing from the torque converter housing using the adjustable bearing puller (25-40 mm) and a commercially available 3/8 "-16 slide hammer (A).
   Fig 1: Removing Countershaft Bearing From Torque Converter Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the ATF guide plate (A) into the housing, then install the new bearing (B) in the direction shown.
   Fig 2: Installing New Bearinging Using ATF Guide Plate

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the bearing (A) in the housing using the driver and the attachment (78 x 80 mm); install the bearing outer notch-cut (B) to a depth (C) of 0-0.03 mm (0-0.001 in.) below the housing surface (D).
   Fig 3: Tapping Bearing Into Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.