FixVault
Home › Acura › 2007 › TL Base › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Consoles › Center Console Panel Removal/Installation

Center Console Panel Removal/Installation

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the front seat, dashboard and related parts.
  • Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
  1. Move the both front seats all the way back.
  2. Remove these items:
  3. A/T model: Remove the trim (A).
    Fig 1: Removing Trim
    G05462150Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. M/T model: Lower the shift lever boot (A) to release the hooks (B) from the boot, then remove the shift knob (C).
    Fig 2: Removing Shift Knob
    G05462151Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the insert panel (A) to release the hooks (B).
    Fig 3: Identifying Panel And Hooks
    G05462152Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Remove the screws (A, B), and detach the clips (C), then remove the driver's console side cover (D) and passenger's console side cover (E).
    Fig 4: Identifying Screws And Clips
    G05462153Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the screws. Pull the center console panel (A) to release the pin (B), and disconnect the accessory power socket connector (C), front accessory power socket light connector (D), and seat heater switch connectors (E).
    Fig 5: Pulling Center Console Panel And Power Socket Light Connector
    G05462154Courtesy of AMERICAN HONDA MOTOR CO., INC.
  8. Turn the center console panel (A), then lift it up and away from the dashboard.
    Fig 6: Turning Center Console Panel
    G05462155Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Remove the screws (A) from the back of the console panel, then remove the panel (B) from the console pocket assembly.
    Fig 7: Identifying Console Pocket Assembly
    G05462156Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Remove the screws (C) from both sides, then remove the pocket A (D) and the pocket B (E) from both pocket supports (F).
  11. Install the console panel in the reverse order of removal, and note these items:
    • Make sure each connector is plugged in properly.
    • Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
    • Push the clips and hooks into place securely.
About FixVault