FixVault
Home › Acura › 2007 › TL Base › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › 4th Clutch Transmission Fluid Pressure Switch Replacement

4th Clutch Transmission Fluid Pressure Switch Replacement

  1. Remove the battery trim and the left upper fender cover.
  2. Remove the intake air duct (see THROTTLE BODY REMOVAL/INSTALLATION ) and the air cleaner assembly (see THROTTLE BODY CLEANING ).
  3. Remove A/T clutch pressure control solenoid valve C (see A/T CLUTCH PRESSURE CONTROL SOLENOID VALVE C REPLACEMENT  ).
  4. Disconnect the 4th clutch transmission fluid pressure switch connector.
  5. Remove the 4th clutch transmission fluid pressure switch (A) and the sealing washer (B).
    Fig 1: Locating 4th Clutch Transmission Fluid Pressure Switch And Sealing Washer With Torque Specifications
    G05458993Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Install a new 4th clutch transmission fluid pressure switch and a new sealing washer, and tighten the switch.
  7. Make sure there is no water, oil, dust, or foreign particles inside the connector.
  8. Install A/T clutch pressure control solenoid valve C.
  9. Connect the connectors securely.
  10. Install the intake air duct (see THROTTLE BODY REMOVAL/INSTALLATION ) and the air cleaner assembly (see THROTTLE BODY CLEANING ).
  11. Install the left upper fender cover and the battery trim.
About FixVault