FixVault
Home › Acura › 2007 › TL Base › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission › Intermediary Shaft Installation Height Inspection/Adjustment

Intermediary Shaft Installation Height Inspection/Adjustment

  1. Install the intermediary shaft (A) in the torque converter housing, and install the 26.5 mm washer (B) on the intermediary shaft.

    Intermediary Shaft Installation Height 

    Standard: 

    133.785-133.885 mm (5.2671-5.2711 in.) 

    Fig 1: Identifying Intermediary Shaft Installation Height
    G05459271Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Intermediary Shaft Cutaway View 

    Fig 2: Cutaway View Of Intermediary Shaft
    G05459272Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install a new gasket (C) on the torque converter housing.
  3. Measure the installed height (D) of the intermediary shaft between the surface (E) of the gasket and the surface of the 26.5 mm washer (F).
  4. If the clearance is out of standard, remove the 26.5 mm washer and measure its thickness.
  5. Select and install a new washer, then recheck the installation height.

    WASHER, 26.5 mm 

    WASHER THICKNESS CHART

    No. Part Number Thickness
    A 90564-RDK-000 1.05 mm (0.041 in.)
    B 90565-RDK-000 1.13 mm (0.044 in.)
    C 90566-RDK-000 1.21 mm (0.048 in.)
    D 90567-RDK-000 1.29 mm (0.051 in.)
    E 90568-RDK-000 1.37 mm (0.054 in.)
    F 90569-RDK-000 1.45 mm (0.057 in.)
    G 90570-RDK-000 1.53 mm (0.060 in.)
    H 90571-RDK-000 1.61 mm (0.063 in.)
    I 90572-RDK-000 1.69 mm (0.067 in.)
    J 90573-RDK-000 1.77 mm (0.070 in.)
    K 90574-RDK-000 1.85 mm (0.073 in.)
    L 90575-RDK-000 1.93 mm (0.076 in.)
    M 90576-RDK-000 2.01 mm (0.079 in.)
    N 90577-RDK-000 2.09 mm (0.082 in.)
About FixVault