Gauge Control Module (Speedo) Trim Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through Honda Canada Inc. Technical Tools Department; Fax #1-866-398-8665/e-mail: ch_technicaltools@ch.honda.com

NOTE:

Take care not to scratch the dashboard and related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

Pry up on the inside edge of the gauge control module (speedo) trim (A) with a trim tool to detach the clips.

Fig 1: Identifying Gauge Control Module Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Using a trim tool, detach the clips, and release the hooks (A) and pins (B) along the edge of the gauge control module (speedo) trim (C), then remove the trim.

Fig 2: Releasing Hooks, Gauge Control Module Trim And Pins
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.