Grab Handle Removal/Installation

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Acura Tool and Equipment Program, call 888-424-6857

NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components

Lower the grab handle (A), then insert a small flat-tip screwdriver wrapped in protective tape into the notch

Fig 1: Inserting Small Flat-Tip Screwdriver Wrapped In Protective Tape Into Notch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use a KTC trim tool (A) to pull on the small flat-tip screwdriver, and remove the cap (B)

Fig 2: Removing Cap
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pinch the clips (A) to release the hooks (B), then remove the grab handle (C)

Fig 3: Removing Grab Handle
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the clips (A) by pinching the hooks with a pair of pliers

Fig 4: Removing Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the side curtain airbag has deployed, replace the grab handle with a new one
If the side curtain airbag has not deployed, inspect the grab handle for damage A damaged grab handle may cause the side curtain airbag to deploy improperly, possibly causing injury Replace the grab handle if it has any of the following damage
- Any cracks or damage in the grab handle (A)
- Any cracks or stress-whitening in the caps (B)
Fig 5: Identifying Grab Handle And Caps
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the clips (A) on the grab handle (B), then insert the caps (C) fully into the clips

Fig 6: Identifying Clips On Grab Handle
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Position the grab handle (A) on the mounting bracket (B), and push on the grab handle until the clips (C) snap into place securely

Fig 7: Positioning Grab Handle On Mounting Bracket

Courtesy of AMERICAN HONDA MOTOR CO., INC.