FixVault
Home › Acura › 2009 › CSX Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 81 (VSA (Vehicle Stability Assist) System Components) › Wheel Speed Sensor Replacement › Front

Wheel Speed Sensor Replacement: Front

WARNING: This page is about a different car, the 2011 Acura TL, 2010 Acura TL, and 2009 Acura TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
  2. Remove the front wheel.
  3. Release the clamp (A), then disconnect the wheel speed sensor connector (B).
    Fig 1: Identifying Clamp, Wheel Speed Sensor And Wheel Speed Sensor Connector
    G06680252Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolts and the wheel speed sensor (C).
  5. Install the wheel speed sensor in the reverse order of removal, and note these items:
    • Do not twist the sensor wires.
    • If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
    • Make sure there is no debris in the sensor mounting hole.
About FixVault