Forced Starting of Display

Special Tools Required

SCS Service Connector 07PAZ-0010100

Remove the trunk trim (see TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
Turn the ignition switch to LOCK (0).
Connect the SCS service connector (A) to the navigation service connector (B) located behind the navigation unit.

Fig 1: Identifying SCS Service Connector And Navigation Service Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II).
Check that the diagnosis menu for the picture diagnosis starts up, and then changes to the system link menu.

NOTE: If the display fails to display the system link screen, refer to no picture is displayed (see SYMPTOM TROUBLESHOOTING ).