FixVault
Home › Acura › 2009 › TSX Automatic › Repair and Diagnosis › External Pages › Different car › Section 29 (Gauges) › Gauge Control Module Replacement

Gauge Control Module Replacement

WARNING: This page is about a different car, the 2008 Acura TSX, 2007 Acura TSX, 2006 Acura TSX, 2005 Acura TSX, and 2004 Acura TSX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Before replacing the gauge control module, (see REWRITING THE ODO DATA AND TRANSFERING THE MAINTENANCE MINDER ON A NEW GAUGE CONTROL MODULE ).
  1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ), then remove the upper column cover (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  2. Place a clean shop towel (A) under the gauge control module to prevent scratching the steering column or dash panel.
    Fig 1: Identifying Shop Towel
    G05492963Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the screws from the gauge control module (B).
  4. Disconnect the 22P and 18P connectors (C), then remove the gauge control module.
  5. Install the gauge control module in the reverse order of removal.
About FixVault