FixVault
Home › Acura › 2010 › MDX › Repair and Diagnosis › Body & Frame › Door Locks › Keyless/Power Door Locks/Security System › Door Lock Switch Test

Door Lock Switch Test

  1. Remove the door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 5P connector (A), remove the two screws, then remove the door lock switch (B).
    Fig 1: Locating 5P Connector, Screws And Door Lock Switch
    G08055267Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.
    • There should be continuity between terminals No. 5 and No. 4 when the door lock switch is in the LOCK position.
    • There should be no continuity between terminals No. 5 and No. 4 when the door lock switch is in the neutral position or UNLOCK position.
    • There should be continuity between terminals No. 5 and No. 3 when the door lock switch is in the UNLOCK position.
    • There should be no continuity between terminals No. 5 and No. 3 when the door lock switch is in the neutral position or LOCK position.
    • There should be continuity between terminals No. 2 (+) and No. 1 (-) (LED check).
  4. If the continuity is not as specified, replace the switch.
About FixVault