Oil Jet Bolt Inspection
- Remove the oil jet bolt (see
OIL FILTER FEED PIPE REPLACEMENT ).
- Inspect the oil jet bolt as follows.
- Make sure that a 0.6 mm (1/64 in) diameter drill bit will go through the oil intake (0.7 mm (0.028 in) diameter). Make sure the check ball (A) moves smoothly and has a stroke of about 4.0 mm (0.157 in)
- Check the oil jet bolt operation with an air nozzle. It should take at least 120 kPa (1.22 kgf/cm, 17.4 psi) to unseat the check ball.
Courtesy of AMERICAN HONDA MOTOR CO., INC.