System Check and Status Log

NOTE: The HDS can be used to:

Check the state of the immobilizer key registration and the IMOCD (S-NET) line by doing a SYSTEM CHECK
Check the number of times the immobilizer-keyless control unit doesn't permit the engine to run by checking the STATUS LOG

Connect the HDS to the data link connector, then turn the ignition switch to ON (II) and follow the prompts to the MAIN MENU
NOTE: If the HDS does not communicate with the vehicle, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING )
At MAIN MENU, enter IMMOBI, then select IMMOBILIZER SETUP
Do the SYSTEM CHECK If there is a system check number, do the troubleshooting for the item indicated
Check the STATUS LOG using the HDS Troubleshoot the line with the highest counts first (see STATUS LOG ) If all the lines are 0 (zero), the problem may not be caused by the immobilizer system, check for ignition or fuel problems

NOTE: Once repaired, clear the status log by removing the No 15(10 A) fuse in the under-hood fuse/relay box or disconnecting the battery