Driver's Switch Panel Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Acura Tool and Equipment Program, call 888-424-6857

NOTE:

Take care not to scratch the trim or the panels
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage

Remove the driver's switch panel (A)
1. -1 Apply protective tape (B) to the dashboard under the edge of the driver's switch panel
2. -2 Pry up on the edge of the panel with a flat-tipped screwdriver wrapped with protective tape to release the hooks (C)
3. -3 Disconnect the VSA OFF switch connector (D) and the headlight washer connector (E) (for some models)
Install the panel in the reverse order of removal, and note these items
- Make sure the each connector is plugged in properly
- Push the hooks into place securely