Automatic Dimming Inside Mirror: Test/Replacement
- Remove the cover (A), then disconnect 7P connector (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode
- Measure the voltage between terminal No 2 and body ground
- If there is less than 0 2 V, go to step 4
- If there is more than 0 2 V, check for
- Open or high resistance in the wire
- Poor ground (G 401)
- Measure the voltage between terminal No 1 and body ground
- If there is battery voltage, go to step 5
- If there is no voltage, check for
- Blown No 12 (7.5 A) fuse in the driver's under-dash fuse/relay box
- Open in the wire
- Measure the voltage between terminal No 3 and body ground with the shift lever in R (reverse) position
- If there is battery voltage, replace the mirror assembly
- If there is no voltage, check for
- Open in the wire
- Faulty driver's under-dash fuse/relay box
- Faulty transmission range switch
- A faulty back-up light switch (M/T)