With SH-AWD
- Remove the rear seat cushion (see REAR SEAT REMOVAL/INSTALLATION )
- Remove the access panel (A) from the right side of the floor
- Disconnect the secondary fuel gauge sending unit 4P connector (B)
- Remove the secondary fuel gauge sending unit from the fuel tank (see SECONDARY FUEL GAUGE SENDING UNIT REMOVAL/INSTALLATION )
- Measure the resistance between the No 1 and No 3 terminals of the secondary fuel gauge sending unit 4P connector with the float at E (EMPTY), 1/2 (HALF FULL), and F (FULL) positions
RESISTANCE REFERENCE
| Float Position | F 6.9 in (176.1 mm) | 1/2 13 in (33.3 mm) | E 1.1 in (27.8 mm) |
|---|---|---|---|
| Resistance (Ω) | 9 to 11 | 453 2 to 444 2 | 453 2 to 444 2 |
NOTE:
Remove the No 15 BACK UP (10 A) fuse from the under-hood fuse/relay box for at least 10 seconds after completing troubleshooting, otherwise it may take up to 20 minutes for the fuel gauge to indicate the correct fuel level