FixVault
Home › Acura › 2011 › TL Base › Repair and Diagnosis › Heating, Ventilation & A/C (HVAC) › HVAC Control Systems › Climate Control System › Climate Control › Passenger's Air Mix Control Motor Replacement

Passenger's Air Mix Control Motor Replacement

  1. Remove the passenger's dashboard undercover (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION )
  2. Remove the glove box (see GLOVE BOX REMOVAL/INSTALLATION )
  3. Release the wire from its harness clip (A), then remove the self-tapping screws and the passenger's heater duct (B)
    Fig 1: Identifying Passenger's Heater Duct And Harness Clip
    G05988693Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the 5P connector (A) from the power transistor, and the 7P connector (B) from the passenger's air mix control motor (C) Remove the self-tapping screws and the passenger's air mix control motor from the heater unit
    Fig 2: Identifying Passenger's Air Mix Control Motor And 7P Connector
    G05988694Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the motor in the reverse order of removal Make sure the pin on the motor is properly engaged with the linkage After installation, make sure the motor runs smoothly
About FixVault