Center Console Armrest Removal/Installation

Special Tools Required 

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; 888-424-6857

1. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
2. Detach the clips, then remove the console trim (A). Disconnect the LF antenna connector (B) and the rear seat heater switch connectors (C), if equipped.
   Fig 1: Disconnecting LF Antenna Connector And Rear Seat Heater Switch Connectors

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the screws (A). Detach the clips (B), and release the hooks (C), then remove the left console side trim (D) and the right console side trim (E).
   Fig 2: Removing Left Console Side Trim And Right Console Side Trim

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the screws, and release the tabs (A), then remove the console outlet trim (B).
   Fig 3: Removing Console Outlet Trim

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Remove the screws. Remove the hinge bushings (A) and the hinge stoppers (B) from both sides, then remove the console armrest (C).
   Fig 4: Removing Console Armrest

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the hinge springs (D) and the bushings (E) from both sides.
7. Install the armrest in the reverse order of removal, and note these items:

• If the clips are damaged or stress-whitened, replace them with new ones.
• Make sure each connector is plugged properly.
• Push the clips, the hooks, and the tabs into place securely.