Driver's Air Mix Control Motor Replacement

Remove the driver's dashboard undercover (see DRIVER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
Remove the self-tapping screws, the aspirator hose (A), and the driver's heater duct (B).

Fig 1: Identifying Aspirator's Hose And Driver's Heater Duct
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the 7P connector (A) from the driver's air mix control motor (B). Remove the self-tapping screws and the driver's air mix control motor from the heater unit.

Fig 2: Identifying Connector And Driver's Air Mix Control Motor
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.