Component Replacement/Inspection After Deployment: Notes
NOTE:
- If the harness is broken or damaged in the areas relevant to the replacement parts shown below, replace the harness, do not repair it.
- Before doing any SRS repairs. Check for DTCs with the HDS (see DTC (DIAGNOSTIC TROUBLE CODES) ) for the less obvious deployed components (front seat belt tensioners, front impact sensors, side impact sensors, rear safing sensor, etc.).
- Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting because it could complicate troubleshooting other DTCs.
- After a vehicle collision, do the ODS unit operation check (see ODS UNIT OPERATION CHECK ).
- After a vehicle collision, inspect the front seat active head restraints (see FRONT SEAT ACTIVE HEAD RESTRAINT INSPECTION ).
After a collision where the front seat belt tensioners deployed, replace these items:
- SRS unit
- Front seat belt(s)
- Front impact sensor(s)
After a collision where the front airbag(s) deployed, replace these items:
- SRS unit
- Deployed front airbag(s)
- Front seat belt(s)
- Front impact sensor(s)
- Dashboard
After a collision where a side airbag deployed, replace the items for the side(s) that deployed:
- SRS unit
- Deployed side airbag(s)
- Side impact sensor(s) (first)
- Side impact sensor(s) (second)
- Seat frame and related parts
- Front seat belt(s)
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
- SRS unit
- Deployed side curtain airbag(s)
- Front seat belt(s)
- Side impact sensor(s) (first)
- Side impact sensor(s) (second)
- Rear safing sensor
- A-pillar trim
- B-pillar upper trim
- C-pillar trim
- Front grab handle
- Rear grab handle
- All related trim clips
- Sunvisor
After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.