Front Impact Sensor Replacement: Removal

Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
Remove the front bumper (see FRONT BUMPER REMOVAL/INSTALLATION ).
Left side: Detach the clip (A), then remove the bolts (B), then release the intake air resonator (C).

Fig 1: Removing Bolts And Releasing Intake Air Resonator
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the left or right engine compartment wire harness 2P connector (A) from the front impact sensor (B).

Fig 2: Identifying Left Or Right Engine Compartment Wire Harness 2P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the TORX bolts (C) using a TORX T30 bit, then remove the front impact sensor.