Ignition Key Switch Test

NOTE: SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or servicing.

Remove the steering column upper and lower covers (see COLUMN COVER REMOVAL/INSTALLATION ).
Disconnect the 6P connector (A).

Fig 1: Identifying Ignition Key Switch 6P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Ignition Key Switch Terminals Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, the ignition key switch is faulty; replace the steering lock (see STEERING LOCK REPLACEMENT ).