FixVault
Home › Acura › 2014 › TSX Base, 4D Sedan › Repair and Diagnosis › Brakes › Traction Control › VSA System Components (4-CYL) › VSA Off Switch Test/Replacement

VSA Off Switch Test/Replacement

  1. Turn the ignition switch to LOCK (0).
  2. Push out the VSA OFF switch (A) from the back of the instrument panel.
    Fig 1: Identifying VSA OFF Switch And 5P Connector
    G07769448Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the VSA OFF switch 5P connector (B).
  4. On the switch side, check for continuity between the VSA OFF switch 5P connector terminal in each switch position according to the table.

    VSA OFF SWITCH 5P CONNECTOR 

    Fig 2: Identifying VSA OFF Switch 5P Connector Terminals
    G07769449Courtesy of AMERICAN HONDA MOTOR CO., INC.
    • If the switch does not work as described in the table, replace the switch.
    • If the switch tests OK, go to step 5.
  5. On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 4 and No. 5. There should be continuity at all times.

    VSA OFF SWITCH 5P CONNECTOR 

    Fig 3: Identifying VSA OFF Switch 5P Connector Terminals
    G07769450Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. If the continuity is not as specified, remove the cover (A), and replace the bulb (B).
    Fig 4: Removing VSA OFF Switch Cover
    G07769451Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Install the VSA OFF switch in the reverse order of removal.
About FixVault