DTC U3000-51: Reprogramming Error (2016-18)
| DTC Description | DTC |
|---|---|
| U3000-51 Reprogramming Error |
DTC (Gauge Control Module)
NOTE:
- Before reprogramming the gauge control module, make sure the 12 volt battery in the vehicle is fully charged, and connect a 12 volt jumper battery (not a battery charger) to maintain system voltage.
- Never press the engine start/stop button to select the ACC or OFF mode, during the reprogramming. If there is a problem with the reprogramming, press the engine start/stop button to select the ON mode.
- Problem verification:
Clear the DTCs with the HDS.
Clear DTCs
- 2. Turn the vehicle to the OFF mode and then the ON mode.
- 3. Check for DTCs with the HDS.
DTC Description DTC U3000-51 Reprogramming Error Is DTC U3000-51 indicated?
YES
Reprogramming the gauge control module.
NO
Intermittent failure, the system is OK at this time.