DTC Troubleshooting: P16F6 (3.0L Engine): Inspection

ST_CUT_RLY2_CL- Shorted Wire Inspection 

NOTICE: 

Before disconnecting the PCM connector, jump the SCS line with the HDS, and wait more than 1 minute.

Test Procedure 

• Preparation
• • Starter cut relay 2: disconnected
  • PCM connector B (72P): disconnected

• Procedure
• • Perform the inspection according to the following table.

    Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.

			(Disconnected)Starter cut relay 2 4P socketfemale terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	ST_CUT_RLY2_CL- shorted to power inspection	ON		Not shorted

Results 

• If abnormal, there is a problem in the circuit.

PCM Inspection 

Test Procedure 

• If the other inspection item (s) indicated a normal condition, then it is determined that the remaining PCM is the cause.

Results 

• There is a problem with the PCM.