EGR Monitor and Readiness Code

NOTE: 

• During the procedure, do not turn the vehicle to the ACCESSORY mode or the OFF (LOCK) mode.
• All readiness codes are cleared when the 12 volt battery is disconnected, if DTCs have been cleared, or if the PCM is reset with the HDS.

Enable Criteria 

ECT Sensor 1 at 176 deg.F (80 deg.C) or more.

Procedure 

1. Connect the HDS to the DLC 

2. Start the engine.

3. Drive at a steady speed with CVT in D or M/T in 4th at 50 - 62 mph (80 - 100 km/h) or above for more than 10 seconds.

4. With CVT in D or M/T in 4th, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this step, repeat steps 3 and 4.Check the OBD status screen for DTC P0011, P0014, P0015, P0016, P0017, P0018, P0019, P0021, P0024, P0025, P0341, P0346, P0366, P0391, P0401, P1008, P1009, P101A, P101B, P25DF, P25E2, P25E5, P25E8, P2651, and P2652 in the DTC's MENU with the HDS.

• If they are passed, the readiness code is complete.
• If they are not passed, go to step 3 and retest.