Transmission Fluid Temperature Sensor Inspection
NOTE:
Since there is no direct method to test the component itself, troubleshooting is performed on the related components.
Test Procedure
Module output voltage inspection
- Preparation
-
- -
Solenoid wire harness A connector (8P): disconnected
- -
- Procedure
-
- Jump solenoid wire harness A connector (8P) terminal No. 6 and No. 7 with a jumper wire.
- Turn the vehicle to the ON mode.
- Confirm the HDS [CVTF Temp Sensor (V)].
(Disconnected) Solenoid wire harness A connector (8P) female terminals
- Normal Conditions
-
- -
HDS [CVTF Temp Sensor (V)] value is less than 0.07V .
- -
Results
- If it is normal, there is a problem with the transmission fluid temperature sensor.
- If it is abnormal, there is a problem with other related components.