Removal And Installation: Rear: Installation
WARNING: This page is about a different car, the 2022 Chrysler Voyager and 2022 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Position the HVACR module (2) to the housing.
- Install and securely tighten the two HVACR module to housing screws (1).
- Connect the HVACR module wire harness connector (3).
- Install the right rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
- Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .